PartCraft Try
0.2

An older version. Open 0.3

PartCraft — parts

Start a part

  1. Pick a plane (click it here or in the history), then Sketch.
  2. Draw with L line, R rectangle, C circle; add dimensions with D and relations from the right panel.
  3. Exit the sketch, then Extrude or Revolve it. Change any number later: the part rebuilds.
  4. Or drop a .partcraft.json or a STEP file here. It opens on this computer; nothing is uploaded.

PartCraft settings

These settings are only for PartCraft, and you can change them only here, in the app.

Turning the view

Left button: drag to turn the part, right or middle drag pans. Middle button: the middle button (the wheel pressed) turns it, Shift + middle or right drag pans, and the left button only picks, so a click never turns the part by accident.

Scrolling

Trackpad: swipe with two fingers to turn the part, hold Shift and swipe to pan, pinch to zoom; in a sketch two fingers pan. Mouse wheel: the wheel zooms at the pointer. "Work it out" treats sideways or fine-grained scrolling as a trackpad.

Sketching

On: a click that snaps to a point or a curve makes it coincident, and nearly level or upright lines become horizontal or vertical. Off: the pointer still snaps, but nothing is tied together until you add relations yourself, so a drag can pull the ends apart.

Theme

The theme applies to every CadCraft app and the site.

Screen

Browsers allow full screen only after a click or key press, so it starts on your first click in the drawing.

Toolbar

Arrange: drag tools within their group, and drag a group by its name.

Panels

You can also drag a panel's inner edge. Double-click the edge to put it back.