Roadmap 0.11, Discord, last sweep before 0.9 (2026-11-05)
FX.30 ModelCraft: Push/Pull stops with "stopped where it touches" and does not say what it touches
Reported 2026-10-19 with two attached models: offsetting a D-shaped face inward and pushing it back moves slightly, then stops with the message; and a circle that should push down to the box level and beyond (a case the reporter said was still not right). Do: name the blocking face or edge in the message and highlight it, and decide whether pushing through into a pocket of the same solid is allowed. Untested; the models are in the Discord thread, not in the repo.
Part built 2026-11-05 (model-fix-09), in /lab. Rebuilt from the description (the originals are in Discord, not here): a D-shaped prism, its top offset inward, the inner face pushed back down stopped at about half the depth. Cause found: the Collide check treated the walls of the pushed face's own solid as a second object, because the inner outline of an offset face shares no edge with the outside (connected() follows edges only). Fix: the pushed face's piece now joins through faces too (pieceOf), so the pocket goes all the way. Also built: when a push or a move is stopped, the tip names what it touches (the object's name, or loose geometry in this group) and the faces it met are highlighted. Tests: test-fix09.mjs (the cause, the fix, the named stop) and browser-fix09.mjs 'FX.30' (loose and in a group, real mouse). Not reproduced: the circle on a box pushed down past its depth; it stops at the box level (clamped by Push/pull itself) with no stop message. If that is what the reporter means, say it is meant; otherwise their model is needed. This is a rebuild of the case, not their file.
Community comments
No comments yet
Add detail as we go: how you would use it, files or steps that show the problem, what other programs do. The team reads every comment.
Sign in or create a free account to add a comment.