Tutorials CivilCraft help Walkthroughs

Utility networks and OpenStreetMap

Runs of water, sewer, storm, gas, power and telecom with material, size, cover and owner; OpenStreetMap data from an Overpass JSON file; crossings, trench sections and volumes; service layers in DWG, DXF and PDF; IFC pipe and cable segments.

Written for CivilCraft 0.10. The same help is inside the app: press F1.

Draw the buried services of a site as one network per service, check where they cross, and send them out as drawing layers and as IFC.

Make runs

Open Surface, More, Utility networks...

  • Make a run from the selection turns the selected alignment, feature line or pipe into a run of the service you chose. Then fill in material, size (mm), cover (the depth to the top of the pipe or cable) and owner in the table.
  • Read OpenStreetMap data reads an Overpass JSON file you saved (a query with out geom;). The project needs a coordinate system first, because OpenStreetMap positions are latitude and longitude. Pipelines (by substance), underground power and telecom cables, hydrants, manholes and storm drains are read; anything else is counted as left out and said in the message. Overhead lines are left out.
  • Add the OpenStreetMap map adds the OpenStreetMap map under the plan. It draws only while map layers from the internet are on in Settings.

Checks and outputs

  • Crossings: runs of different services that cross in plan are listed with the clear height between them where there is a ground surface; the minimum is a placeholder you set, not a standard's number.
  • Trench: each run gets a trench (pipe size plus clearance each side, side slope, bedding) with a volume. The total shows in the window and in the CSV.
  • Drawing: runs and points are on service layers (for example U-WATR-RUN, U-POWR-RUN), so they reach PDF, DXF and DWG.
  • IFC: runs go into the IFC export as pipe segments and cable segments, with hydrants, valves and chambers, one system per service, in the project's coordinate system.

OpenStreetMap data

OpenStreetMap data is copyright OpenStreetMap contributors and licensed under the ODbL. The attribution is added to the drawing, the CSV and the IFC. If you share a file that holds OpenStreetMap data, keep the attribution and read the licence's share-alike terms.

What is not done

Runs are not drawn point by point on the plan with a tool yet, and crossings are not drawn in the profile view yet (the calculation is built). Depths, sizes and clearances start as placeholders: use your own standard's numbers.