Tutorials BimCraft help Walkthroughs

Drawing advice: unusual sizes are made, with a warning

BimCraft makes what you ask for. A size outside what is usual becomes a warning in Problems; it never stops you drawing or saving.

Written for BimCraft 0.10. The same help is inside the app: press F1.

What you'll do

Draw a size that is not the usual one, and see where BimCraft tells you about it.

Steps

  1. Draw or change the element as you want it: for example a stair 400 mm wide.
  2. BimCraft makes it as asked.
  3. Open Problems in the top bar. Under Drawing advice there is a warning that names the element, the size you gave and the usual range.
  4. Click the warning to select the element. Change the size if it was a slip, or leave it: a warning can be accepted, with or without a reason.

What is advice

These used to be refused. They are made now, each with a warning:

  • Stairs: narrower than 500 mm or wider than 5 m; risers outside 100 to 300 mm; treads outside 150 to 600 mm.
  • Spiral stairs: a post outside 40 to 400 mm; treads under 100 mm deep on the walk line.
  • Columns: under 50 mm across or under 300 mm tall.
  • Ramps: under 300 mm wide.
  • Doors and windows: under 100 mm wide or tall.
  • Grid lines: under 100 mm long.
  • Walls: a wall left under 50 mm long, for example by a trim.
  • Levels: under 1 m or over 100 m tall (new building, split levels, a level's height).
  • Dormers: outside 600 mm to 12 m wide, a front wall outside 300 mm to 4 m, an overhang over 1 m, walls outside 50 to 400 mm.
  • Building pads: side slopes outside 1:1 to 10:1.

What is still refused

Only what cannot be built or found, each with a message that says why:

  • A size under 10 mm (a wall under 1 mm): there is nothing to build.
  • A dormer not wider than twice its wall thickness: its two side walls would meet.
  • A building pad with side slopes steeper than 0.1:1 (that is a retaining wall) or flatter than 100:1 (the grading would run on without end).
  • Something that does not fit where you put it, an outline that crosses itself, or an element that is no longer in the model.

Good to know

  • The advice is worked out from the model, so it is there again when you open the file later, and it goes when the size is put right.
  • Model checks, regulation packs and IDS checks also only list what they find. Nothing in Problems stops you drawing or saving.
  • The usual ranges are general practice, not a building code. For a code, add the Building regulations add-on and pick your place.

Next