Tutorials BimCraft help Walkthroughs

Wall finishes, tile set-out and substrates

Put finishes on the two faces of a wall, lay out tiles from a start point, set the substrate layers behind them, and read the quantities in the wall finish schedules.

Written for BimCraft 0.10. The same help is inside the app: press F1.

What you'll do

Finish the faces of walls (paint, board, tile) and read how much of each finish the building needs.

Steps

  1. Open Draw › Walls › Wall finishes…. A panel opens over the drawing.
  2. Pick a wall. On the Face tab choose its left or right face, then add a finish: Full height, Splash-back, Shower wall or By corners.
  3. For a tile finish, choose where the set-out starts (a corner, the centre, an opening's edge or a point), the tile direction and a straight or brick pattern. The count of whole and cut tiles shows at once.
  4. On Finish types make or change a type: name, kind, the tile size and joint, waste, and the build-up from the wall outwards (substrate, waterproofing, adhesive, finish).
  5. On Substrates change the substrate layers on their own and read what the wall measures finished.
  6. On Schedules read the wall finishes by zone, by finish and by room.

What you should see

  • The finishes drawn in the plan and as coverings in the model; moving or retyping a wall moves its finishes with it.
  • Every change is one undo step.
  • Quantities net of openings. Tile counts marked with ≈ are estimates.

Good to know

  • The panel advises and never blocks.
  • Wall finishes also appear in Schedules as Wall finishes by zone, by finish and by room.