Tutorials BimCraft help Walkthroughs

Rooms and room separators

Pick a room to name and number it and read its area, perimeter and volume. Draw a room separator where two rooms meet with no wall between them.

Written for BimCraft 0.10. The same help is inside the app: press F1.

What you'll do

Name the rooms the walls make, and divide an open room into two without a wall.

Where the tools are

  • Ribbon layouts: Architecture › Room & Area › Room and Room Separator.
  • Classic layout: the Draw bar › Rooms menu.
  • Any menu style: the commands are named Room and Room Separator; the command palette finds them.

Steps

  1. Draw the walls. Every closed loop of walls is a room already: BimCraft makes it, numbers it and gives it its area as you draw.
  2. Choose Room. Move over the plan: the room under the pointer lights up with its area, perimeter and volume.
  3. To name rooms quickly, type a Name and a Number in the row first, then click in the room. The number goes on by one for the next room (101, 102; A-09, A-10).
  4. Or just click a room: it is picked, and Properties has its name, number, area, perimeter, volume and its tag.
  5. To split an open room, choose Room Separator and click two points: wall to wall, or wall to another separator. Carry on clicking for a chain; Enter, Esc or a double-click ends it.

What a separator does

  • It bounds rooms like a wall with no thickness. The two rooms' areas add up exactly to the room they were.
  • The room that holds the old room's middle keeps its name and number. The other is new.
  • A separator that stops in the open, touching nothing at one end, divides nothing. Extend it and it will.
  • The part of a separator that lies inside a wall is ignored, so you can snap to wall centre lines.
  • Pick a separator and press Delete to remove it: the two rooms become one again. Undo puts it back.

If there is no room where you click

The status line says so: the walls do not close there. Close the gap, or draw a separator across it. Nothing is refused; there is simply no closed room yet.

In the IFC

A room is an IfcSpace with its number (Name), name (LongName) and Qto_SpaceBaseQuantities: NetFloorArea, NetPerimeter, Height, NetVolume. The volume is the area times the height to the level above.

A room separator is an IfcVirtualElement, the entity IFC has for a boundary that is not built. It has a line and no body, so another program reads no wall and counts nothing for it.

Not built yet

  • Curved separators.
  • A room that follows a sloped ceiling: the volume is always area times the level height.
  • Space boundary relations (IfcRelSpaceBoundary) are not written, for walls or for separators.

See also Room and area tags, Areas and area boundaries.